Application: Support Most of 7-15 in LCD/DLP 3D printer

Most resins have an ideal printing temperature is about 25℃(77℉). If the temperature falls below this, the resin can become viscous, resulting in reduced print quality and even print failure. So we designed this small heater for resin printers. to help you can expect better printing results! Our Professional design heaters are built for reliability and safety. It's can 24/7 running.

How to install:

1.Put the heater to the left of 3D printer Z-axis, please do not block the way of Z-axis.

2.Make the power cable (5mm) come through the printer tank.

3.Remove the bottom tape, paste and fix it on the left side of the Z-axis of the printer.

How to use:

1. Setting a target temperature(25℃~30℃).

2. Wating temperature rise to target temperature and waiting resin get warm.

3. Start to printing.

Why you need a heater for your Resin 3D printer in winter？

Most resins have an ideal printing temperature is about 25℃(77℉). If the temperature falls below this, the resin can become viscous, resulting in reduced print quality and even print failure. So we designed this small heater for resin printers. to help you can expect better printing results!

Of course, you can DIY a heater yourself, but this may have safety problems. Our Professional design heaters are built for reliability and safety. It's can 24/7 running.

How to install:

1.Put the heater to the left of 3D printer Z-axis, please do not block the way of Z-axis.

2.Make the power cable (5mm) come through the printer tank.

3.Remove the bottom tape, paste and fix it on the left side of the Z-axis of the printer.

How to use:

1. Setting a target temperature(25℃~30℃).

2. Wating temperature rise to target temperature and waiting resin get warm.

3. Start to printing.

Remark:

1. Please use it indoor.
2. Please do not use it in non-3D printer scenarios.
3. If there is no hole, you need to drill a hole in the tank（Power cord 5mm）.
4. The heating speed is due to the room temperature and enclosure size, if heating speed is too slow, please cover the enclosure with a blanket.